OPT-SNAP-PAC-RCK8FM

SNAP-PAC-RCK8-FM SNAP PAC 8-Module Mounting Rack, Factory Mutual Approved

The SNAP-PAC-RCK8-FM mounts one SNAP PAC brain or on-the-rack controller and up to 8 analog, digital, serial, and
special-purpose SNAP I/O modules. The SNAP-PAC-RCK8-FM can be DIN-rail or panel mounted.
 
This rack works with all SNAP I/O modules on the Opto 22 website. Analog, digital, and serial modules can be mixed on
the rack and placed in any position. (Some serial modules are limited to a maximum of eight on one rack. See module
data sheets for limitations and power requirements.)
 
Together with I/O modules and a brain or rack-mounted controller, this rack forms an I/O unit that provides distributed
control in a SNAP PAC System. The I/O unit can also be used for PC-based control or as intelligent remote I/O for an
Allen-Bradley MicroLogix PLC or other RSLogix-based system, such as ControlLogix or CompactLogix.
 
The SNAP-PAC-RCK8-FM is Factory Mutual-approved. If you do not need FM approval, see the SNAP-PAC-RCK8.
 
Other SNAP PAC racks available:
SNAP-PAC-RCK4-FM for 4 modules
SNAP-PAC-RCK12-FM for 12 modules
SNAP-PAC-RCK16-FM for 16 modules
 

Power1 Requirements	5.0 to 5.2 VDC @ 4.2 Amps max
I/O Processor2 Compatibility	SNAP-PAC-R1 SNAP-PAC-R2 SNAP-PAC-EB1 SNAP-PAC-EB2 SNAP-PAC-SB1	SNAP-PAC-R1-FM SNAP-PAC-R2-FM SNAP-PAC-EB1-FM SNAP-PAC-EB2-FM SNAP-PAC-SB2
Replacement Fuse	SNAP-FUSE7.5AB or Littelfuse 297 07.5
Rack Power Terminals Wire Size	22 to 14 AWG
Operating Temperature	0 to 70 °C
Relative Humidity	95%, non-condensing
1 Power requirements shown are for a rack, a processor, and a full load of analog modules. Power requirements for SNAP serial and high-density modules are higher.   2 “I/O Processor” means a SNAP PAC brain or SNAP PAC on-the-rack controller.

Rev: 04/13