Did you forget your password?
© 2013 Uwe Wannags Hard-+ Software Distribution e.K (SWD)
HIL-NT50-MPI
NT50-MPI 1758.111 netTap-MPI S7-200/300/400 Ethernet programming adaptor
Monitoring, programming and visualizing S7-PLCs over Ethernet
.jpg)
Highlights ?
Parallel communication to 32 PLCs with up to 16 TCP connections ?
Direct PLC to PLC communication, also as projected connection ?
For all S7 Engineering Tools inclusive TIA Portal ?
Web based confi guration, protocol support of RFC1006 and DHCP ?
Full access to PROFIBUS diagnostics and services in STEP7® ?
Automatic DP/MPI baud rate detection
As directly mountable or as firmly attachable DIN rail mountable device the adaptors netLINK- and netTAP-
MPI are replacing expensive CP communications processors and allow the programming, visualization and
control of S7-200®, S7-300® or S7-400® PLCs over Ethernet.
The provided driver integrates into all well-known SIMATIC S7® engineering tools like STEP7® or TIA portal
as PG/PC programming interface. The device is setup within the engineering tool or with conventional web browsers over the integrated web configuration pages.
The adaptors are suitable to program or change S7-PLC control programs and may serve to engineer HMI
devices with the visualization software WinCC. By supporting the „ISO on TCP“ RFC1006 Ethernet protocol
any third party or SIMATIC® visualization stations can be coupled to the PLC. Once integrated into the office
or plant network and connected to the internet also remote maintenance and logging over a router is possible since plain TCP/IP protocol access mechanisms are used.
Organized in a network direct communication between two or several PLCs over Ethernet can be realized.
Even a coupling of PLCs with no own Ethernet port is possible using two adapters in conjunction. Featuring
full PROFIBUS diagnostics and Master Class 2 DPV1 services enables unrestricted DP Slave device configu-
ration and parameterization in STEP7®.
Power is supplied by a 24 V DC. If supported by the S7 PLC the netLINK-MPI adaptor may be powered over
the DSUB9 connector alternatively and its extra feed-through DSUB9 connector allows the connection of
further devices to the same MPI/DP network.
Rev: 01/19