OPT-SNAP-AOV-5

SNAP-AOV-5 SNAP 1-Ch 0-10VDC Analog Voltage Output Module

The SNAP-AOV-5 provides a single channel of digital-to-analog conversion. The module has a true differential (floating)
output that eliminates ground loops and has a nominal output range of 0-10 VDC. The module is transformer isolated
and optically isolated from other modules and devices, and is factory calibrated.
 
Part of the SNAP PAC System, the module mounts on a SNAP PAC rack with a SNAP PAC brain or rack-mounted
controller. Analog, digital, and serial I/O modules can all be on the same rack. Such an I/O unit is also well suited for
PC-based control or for use as intelligent remote I/O for an Allen-Bradley MicroLogix or other RSLogix-based PLC
system, such as ControlLogix or CompactLogix.
 
For a similar two-channel module, see SNAP-AOV-25.
 

Input	12-bit serial data
Outputs	0 to +10 Volts DC (floating)
Span	10 Volt span
Resolution	2.44 mV
Response Time (% of span/delta V/delta time)	99.9%/19.98 V/3 mS
DC Common Mode Rejection	>-120 dB
AC Common Mode Rejection	>-120 dB @ 60 Hz
Maximum Operating Common Mode Voltage	250 V
Common Mode Resistance	>1000 Megaohms
Load Current	10 mA (floating)
Short Circuit Current Continuous	125 mA (typical)
Accuracy	0.1% of Span
Gain Temperature Coefficient	50 PPM/°C
Offset Temperature Coefficient	20 PPM/°C
Power Requirements	5 Volts DC @ 150 mA
Ambient Temperature:   Operating   Storage	0 °C to 70 °C -25 °C to 85 °C
Agency Approvals	UL, CE, FM, RoHS, DFARS
Warranty	Lifetime

Rev: 04/13