OPT-SNAP-LCE

SNAP-LCE SNAP Ethernet compact industrial controller for ioProject systems

NOTE: Although fully supported and still in production, this is a legacy product and not recommended for new designs.
For new designs, see the standalone SNAP-PAC-S1 and the rack-mounted SNAP-PAC-R1 controllers. SNAP PAC
controllers provide more power and additional network connections. SNAP PACs run PAC Control strategies; ioControl
strategies can be simply upgraded to PAC Control.

------------

The SNAP-LCE is a stand-alone, small-footprint, Ethernet industrial controller designed for use with SNAP Ethernet I/O
units and the ioProject software suite. The SNAP-LCE provides real-time control and is used primarily in industrial
control applications. It is programmed with the included ioControl.

NOTE: The SNAP-LCE controller is NOT compatible with FactoryFloor.
 

Processor	32-bit ColdFire® 5407
Memory   Total RAM   Battery-backed RAM   Flash EEPROM	16 MB 512 KB 8 MB (7 MB with firmware version 7.2)
Backup battery	3-volt CR2032 Lithium, user replaceable. Typical service life with power off: 5 years.
Host communication	Ethernet (10/100 Mbps) or PPP (dial-up and radio modem)
I/O communication	Ethernet (10/100 Mbps)
I/O unit compatibility	Opto 22 SNAP Simple I/O, SNAP Ethernet I/O, and SNAP Ultimate I/O units
Serial ports	Two RS-232 ports. Baud rate is soft-selectable from 150–115,200 kBd.
Power requirements	5.0–5.2 VDC at 1.2 A
Operating temperature	0 °C to 60 °C
Storage temperature	-40 °C to 85 °C
Humidity	0% to 95% relative humidity, non-condensing
Software	ioProject software suite (ioControl, ioDisplay, ioManager) Purchase OptoOPCServer separately to communicate using OPC.
Other features	FTP server/client with file system Real-time clock

Rev: 04/13