SWD-PCIe-20mA-Current-Loop

Product 30 of 34
Zoom
PCI Express Card 2x 20mA, 1kV isolated, for Windows 9x/NT4.0/2000/XP/2003/Vista/2008/7/2008R2/8.1/2012R2/10
plus VAT Weight: 0.2 kg Empfohlen Recommended Neu New

PCI Express Card 2x 20mA, 1kV isolated

Product properties:

  • Two 20mA ports on one PCI Express Card
  • 1kV galvanic isolation between the PC and the two serial ports
  • UART with 128-byte FIFO and DMA capability for relieving the CPU
  • Compact "x1" plug-in card for any PCI Express slots
  • Compatible with PCI Express Standard 1.1 and PCI Power Management Standard 1.2
  • Includes drivers for Windows 2000, XP, Vista, 7, 8 and Linux
  • Conforms to standards both in office and industrial environments:
    • Increased noise immunity for industrial areas
    • Stricter noise emission for residential and commercial areas
  • 5 year guarantee


Background information:

In current PC designs PCI Express is increasingly replacing the established PCI bus system. There are still PC motherboards which offer slots for both systems, but future designs will for cost and performance reasons likely be equipped with PCI Express slots only.

PCI Express is not a traditional PC bus system in which all plug-in cards are in parallel with the majority of bus lines. PCI Express is rather a star type wiring technique using a point-to-point connection between the PC and plug-in card to allow significantly greater transmission speeds than a bus solution with parallel wired slots would be able to process.

Data transmission to the plug-in cards in PCI Express is serial using differential wire pairs, so-called "lanes", which run at a speed of 2.5 or 5 GB/s. For cards with high data throughput (graphics and network cards, hard drive controllers), multiple lanes are routed to a slot, whereas cards with less complexity get by easily with one lane.

The PCI Express standard enables solutions in which one (x1), four (x4), eight (x8) or 16 (x16) lanes are routed to a slot, with the connectors differing in the mechanical configuration, pin configuration and load capacity of the supply voltage.

The mechanical coding of cards and connectors ensures however that short cards can be easily used in long slots. For example, a x1 card can be used in a x4, x8 or x16 slot.

 

Technical data:

Number of ports:   2 galvanically isolated 20mA ports
Operating modes:    active or passive mode
can be set for all 20mA loops individually
UART:   Oxford OXPCIe954 with 128 bytes FIFO
Base addresses:   automatic configuration
Interrupts:   automatic configuration
Baud rate:   50 .. 57600 baud
Data format:   any format
Signal lines:   RxD+, RxD-, TxD+, TxD-
Serial connections:   9-pin SUB-D connector
PCIe terminal:   "x1" connector
Galvanic isolation:    Isolation voltage min. 1 KV DC
between PC and serial ports
Power supply:   +3.3V, 0.2A (typ.), +12V, 0.2A (typ.)
Dimensions:   105 x 93 mm
Ambient temperature:   Storage: -40..+70°C, Operation: 0..+70°C
Permissible relative humidity:   0..95% RH (non-condensing)
Weight:   approx. 100 g
Delivery:   1x PCI Express Card 2x 20mA
Driver CD

Rev: 04/17

* plus shipping