COR-CT-FE120

CT-FE120

CorNet 100TX Fast Ethernet Adapter PCI

Supports: 100Mbps 100base-TX Fast Ethernet (IEEE 802.3u) 10Mbps 10base-T Ethernet (IEEE 802.3) 32 bit bus mastering Supports boot ROM Fully software configurable Drivers for QNX, Netware, Windows, etc. Diagnostic link LEDs Auto-negotiation for 100Mbps or 10Mbps operation on single RJ-45 network connector +5VDC, 0.5A typical

• Uses 2 pairs of unshielded twisted pair cabling (category 5 for 100base-TX Fast Ethernet or category 3 for 10base-T Ethernet)

This 100Mbit extension to the Ethernet standard allows significantly increased network throughput over 2 pairs of category 5 twisted pair wiring. The CorNet Fast Ethernet products are guaranteed to work with QNX.

DESCRIPTION

This is a 32-bit Bus Mastering Fast Ethernet Adapter for the PCI bus. It supports both 100Mbps Fast Ethernet and 10Mbps Ethernet connections to allow a gradual upgrade to a network. If appropriate cabling is present, simply attach the cable to a 100TX Hub on the network. The adapter will switch automatically to whatever network it is attached. It supports jumperless Plug and Play configuration.

OPERATING ENVIRONMENT

• Power: +5V DC @ 0.5A max
• Operating Temperature: 0 to 40ºC
• Storage Temperature: 40 to 70ºC
• Operating Humidity: 10% to 90% (non-condensing)
• Storage Humidity: 5% to 90% (non-condensing)

LAN INTERFACE

• 32-bit bus mastering PCI 2.0 bus
• 100 or 10Mbps transmission rate
• I/0 mapped (set by PCI BIOS)
• Interrupts (set by PCI BIOS)
• ROM: Optional Boot ROM
• PnP jumperless configuration by PCI bus
• Autodetect 100 or 10 Mbps network
• Drivers for most popular networking operating systems

PHYSICAL SPECIFICATIONS

• PCB mounted low profile RJ45 connector
• LED indicator for link, green - indicates link is operating normally, yellow - indicates node activity
• Standard PCI adapter: 125mmx80mm (4.92"x3.15")

WARRANTY

• 5 years

INSTALLATION CONSIDERATIONS

ETHERNET

Twisted Pair Cable Type

• Category 3 or better unshielded twisted pair

• From node to hub: 100m (325 ft)
  Total network span: 500m (1320 ft)
  Based on recommended maximum of 5 links and 4 repeaters between nodes.

FAST ETHERNET

• Category 3 or better unshielded twisted pair

• From node to hub: 100m (325 ft)
  Total network span: 205m (670 ft)

CONFORMS TO THE FOLLOWING STANDARDS

• 100TX: IEEE 802.3u 100base-TX
• Ethernet: IEEE 802.3 10base-T
• EMC:

• EN55022:1994, CISPR 22 Class A
• EN50082-1

• IEC 801-2, 8KV Air
• IEC 801-3, 3V/m
• IEC 801-4, 0.5KV Signal line, 1KV Power line

Rev: 07/20